# Three concept directions — yard-scale kinetic wind sculpture

Assumptions: one anchor point, motion legible from thirty feet, honest mechanism. No prices
or structural figures — this is a form decision.

## 1. Grassline — a field of leaning stalks

- **Visual idea:** 25–30 slender vertical vanes in a loose drift, pale green and bone,
  reading as a patch of tall prairie grass that happens to be metal.
- **Motion in wind:** No rotation anywhere — each stalk bends on a spring-steel flexure at
  its base and springs back, and with no two stalks sharing a length or stiffness the patch
  bends in travelling waves. In a hard wind it lies over and hums.
- **Built from:** 3/4"–1" thin-wall aluminium tube or pultruded fibreglass stalks; 0.040" 301
  spring steel flexure feet; one cast concrete pad under a single bolted base plate;
  powder-coat in four or five greens.
- **Biggest risk:** Fatigue at the flexure, the one place a repeated bend concentrates — a
  stalk that work-hardens and snaps becomes a spear. Either reckon the design life in cycles
  or add a stop so the bend never reaches the plastic range.

## 2. Slow Bloom — a balanced cantilever with spinning cups

- **Visual idea:** A long tapered boom balanced on one pivot like a scale beam, carrying five
  shallow bowls on staggered stalks, so it looks like a flowering branch stopped mid-swing.
- **Motion in wind:** Three speeds at once — the boom weathervanes to face the wind, rocks
  slowly as the load shifts, and each bowl spins at its own rate on its own axis. From the
  street you see the grand slow turn; from the patio, the flicker of one cup.
- **Built from:** Welded mild-steel tube armature (zinc-rich primer plus enamel, or hot-dip
  galvanised); spun aluminium or polycarbonate bowls; one large sealed thrust bearing at the
  main pivot, one small shielded bearing per bowl; stacked-plate counterweight; single pier
  footing.
- **Biggest risk:** It is a bearing machine — one sticky bowl stops turning and the piece
  reads as broken, so the bearings must survive dust and freeze-thaw. Subtler risk: one pivot
  too many and it is a Calder knockoff rather than a piece.

## 3. Wind Curtain — a hanging wall of turning leaves

- **Visual idea:** Hundreds of small flat leaves, bright on one face and dark on the other,
  hung in a grid from a rigid overhead beam — a shimmering veil about eight feet wide by
  seven tall, rising out of a hedge.
- **Motion in wind:** Each leaf turns on its own vertical wire pivot, so the curtain breathes:
  waves of alignment travel across it and faces flip bright to dark as the wind shifts.
- **Built from:** 1/8" stainless cable or 1/16" monofilament grid under tension; stamped
  0.025"–0.032" aluminium leaves with one anodised or copper face; acetal or nylon bushings
  rather than bearings; welded steel beam on two posts.
- **Biggest risk:** Hundreds of pivots times hundreds of wind-catching surfaces means hundreds
  of places to tangle, seize or shed a leaf — it needs a stop per leaf and a real service
  plan, and non-uniform leaf stock will make it look like a craft project.

## How they differ

| | Movement | What you see | Maintenance |
|---|---|---|---|
| Grassline | flexure, no bearings | a field moving as a field | low, but fatigue-critical |
| Slow Bloom | pivots on several axes | one object at three speeds | bearings and pivot seals |
| Wind Curtain | suspension, many tiny pivots | a surface, not an object | highest — many small parts |

Next step: pick one and it becomes the documented concept this project is aiming for — form
description, materials shortlist, cut-list-level build plan. Nothing is ordered or cut before
that choice.
